Install EleksTubeIPS firmware

Version 2.1.13 of judge2005/EleksTubeIPS, replacement firmware for the EleksTube IPS clock and its clones. Use this page to:

1Before you start

2Choose your clock

Clock

Some clocks sold as an EleksTube IPS V2 need the V1 firmware. If every display shows the same digit after installing, install the other EleksTube version with Upgrade. Your settings are kept.

3Install

Some clocks have to be manually put into programming mode before installation (e.g. the IPSTube clocks). You do this by holding down the power button while you plug it in - the display will stay blank when you do this.

 

Upgrade

For a clock that already runs this firmware, 1.9.4 or later. Installs only the firmware, so your settings, Wi-Fi details and uploaded images are kept.

When asked, leave Erase device unticked. Erasing removes everything, and the clock won't start again until you do a full install.

Needs Chrome or Edge on a computer. Needs an HTTPS page.

Full install

For a clock running its original firmware, or to start over. Also installs the default clock faces, weather icons and slide shows, replacing any you've uploaded.

On a first install, tick Erase device when asked. Leave it unticked to keep your settings and Wi-Fi details.

Needs Chrome or Edge on a computer. Needs an HTTPS page.

Choose your clock to turn on these buttons.

4Connect to Wi-Fi

Configure Wi-Fi

Installing the firmware should give you the option to configure Wi-Fi, but you can use the button below to just configure your clock's Wi-Fi settings.

If you had to manually put your clock into programming mode - unplug it and plug it back in before you use this feature.

Needs Chrome or Edge on a computer. Needs an HTTPS page.

If that doesn't work there are other ways to do it. The Connecting to WiFi in the wiki walks you through it. After that, open the clock's web page to set it up.